
Glass Clamp - Glass Adapter - 2 PK
GA0.000.000.PMT.030
Regular price Sale price $45.98ANSI 316 Stainless Steel Glass Adapter connects a glass panel to a wall with a simple, modern, and floating look. This adapter is designed to work with 1/4", 3/8", 1/2", 5/8" or 3/4" glass thickness.
Glass Adapter should be installed with a maximum distance of every 4 feet.
Caution: Wear protective ANSI approved safety glasses, working gloves, and mask at all times
Tools Required
- Drilling tool for substrate
- 1/4” drill bit
- The holes require on glass are 1” in diameter.
Instructions
- When using a 3/8” lag screw, spot drill using 1/4” drill bit, different mounting surfaces require different methods.
- Begin with only the mounting sleeve with the appropriate screw
- Twist the standoff column (#3) onto the sleeve.
- Insert the gasket #4, place the glass in place, then gasket #5, and then place cap #6 and screw in over the glass. The hole size on the glass is 1” in diameter.
Downloads:
Download - PDF Instructions
NOTE: A small amount of surface corrosion is not uncommon after some exposure to weather or salty conditions; we recommend using our passivation solution to prevent surface corrosion; more information available on our Tip Sheet on Passivation">
Overview
These instructions will provide step-by-step installation guidelines for installing the Glass Adapter. The Glass adapter comes with 2 round rubber gaskets, a standoff column (30/40 mm), and the mounting sleeve (you will need to purchase the connection screw separately).
Glass Adapter should be installed with a maximum distance of every 4 feet.
Caution: Wear protective ANSI approved safety glasses, working gloves, and mask at all times
Tools Required
- Drilling tool for substrate
- 1/4” drill bit
- The holes require on glass are 1” in diameter.
Instructions
- When using a 3/8” lag screw, spot drill using 1/4” drill bit, different mounting surfaces require different methods.
- Begin with only the mounting sleeve with the appropriate screw
- Twist the standoff column (#3) onto the sleeve.
-
Insert the gasket #4, place the glass in place, then gasket #5, and then place cap #6 and screw in over the glass. The hole size on the glass is 1” in diameter.
Downloads:
Download - PDF Instructions
NOTE: A small amount of surface corrosion is not uncommon after some exposure to weather or salty conditions; we recommend using our passivation solution to prevent surface corrosion; more information available on our Tip Sheet on Passivation.